Side-Power RC-10E Manual de usuario

Made in Norway© Sleipner Motor AS version 1.1 - 2010SE170/250TC Ignition Protected thruster assemblySLEIPNER MOTOR ASP.O. Box 519N-1612 FredrikstadN

10SE170/250TC Ignition Protected thruster assembly 1.1 - 2010• You can install as many panels as you wish by using optional Y-connectors. If tw

11SE170/250TC Ignition Protected thruster assembly 1.1 - 2010 11SP75Ti / SP95Ti ignition protected thruster assembly 1.2.1 - 2007"Visua

12SE170/250TC Ignition Protected thruster assembly 1.1 - 2010 12SP75Ti / SP95Ti ignition protected thruster assembly 1.2.1 - 2007SLEIPNERSID

13SE170/250TC Ignition Protected thruster assembly 1.1 - 2010 Propeller is fastened correctly to the shaft. Propeller turns freely in tunnel

14SE170/250TC Ignition Protected thruster assembly 1.1 - 2010 Ensure that you know the location and how to operate the main battery switch and

15SE170/250TC Ignition Protected thruster assembly 1.1 - 2010How to use a bowthruster1. Turn main power switch for the bowthruster on. (Always

16SE170/250TC Ignition Protected thruster assembly 1.1 - 2010Warning: Tampering with the Ignition Protected stern thruster assembly or any att

17SE170/250TC Ignition Protected thruster assembly 1.1 - 2010Before seeking assistance at the help desk of your Sidepower dealer / distributor p

18SE170/250TC Ignition Protected thruster assembly 1.1 - 20101. The equipment manufactured by Sleipner Motor AS (The “Warrantor”) is warranted t

19SE170/250TC Ignition Protected thruster assembly 1.1 - 2010SE 170/250 TC24VRef:Part #SE 170/250TCOriginal modelModel period9181 2345 2 1 3 4 5

2SE170/250TC Ignition Protected thruster assembly 1.1 - 2010Technical specications ...

Service CentresSleipner Motor AS • P. O. Box 519, N-1612 Fredrikstad • Norway Tel: +47 69 30 00 60 • Fax: +47 69 30 00 70 • sidepower@sleipne

3SE170/250TC Ignition Protected thruster assembly 1.1 - 2010Prior to installation, it is important that the installer reads this guide to ensure

4SE170/250TC Ignition Protected thruster assembly 1.1 - 2010Fig. 1Bolt on installation of the stern tunnel1. Make sure that there are enough sp

5SE170/250TC Ignition Protected thruster assembly 1.1 - 2010Boat transom Boat transomStern tunnelGrind off the bolt ange and the gelcoat both i

6SE170/250TC Ignition Protected thruster assembly 1.1 - 2010Fitting gearhouse and motor bracketFig. 1 12SP 155 TCi / SP 200 TCi / SP 240 TCi / S

7SE170/250TC Ignition Protected thruster assembly 1.1 - 2010Fitting propellers53214Locktite1. Push the propeller onto the shaft, carefully rota

8SE170/250TC Ignition Protected thruster assembly 1.1 - 20101. Remove the 4 bolts in the motorbracket.2. Mount the lower part of the exible c

9SE170/250TC Ignition Protected thruster assembly 1.1 - 2010• Explanation of electrical table- All cable lengths are the total of + and - (to a