Side-Power SEP 100/185 T Manual de servicio descargar pdf (Pagina 194)

Section 914

GARMIN GTX 328 Transponder

914 - 6 Page Date: 4. Februar 2011

Pilot´s Operating Handbook

EXTRA 330LX

'ALTITUDE MONITOR'

The ALTITUDE MONITOR function is not available in this installation.

'OAT/DALT'

The OAT/DALT function is not available in this installation (no temperature input).

'COUNT UP TIMER'

Controlled by the START/STOP and CLR keys. Pressing the CLR key zeros the display.

'COUNT DOWN TIMER'

Controlled by START/STOP, CLR, and CRSR keys. The initial Count Down time is entered with

the 0 - 9 keys. Pressing the CLR key resets the timer to the initial value.

'STBY'

The transponder will not reply to any interrogations.

'GND'

This page is not active.

'CONTRAST'

This page is only displayed if manual contrast mode is selected during installation configuration.

Contrast is controlled by the 8 and 9 keys.

'DISPLAY'

This page is only displayed if manual backlighting mode is selected during installation configuration.

Backlighting is controlled by the 8 and 9 keys.

914.1.5 CONFIGURATION MODE

The configurartion mode is not active.

The GTX 328’s options are normally set at time of installation. To request any changes of the GTX

328 parameters, contact an authorized Garmin Aviation Service Center.

914.1.6 ALTITUDE TREND INDICATOR

When the 'PRESSURE ALT' page is displayed, an arrow may be displayed to the right of the

altitude, indicating that the altitude is increasing or decreasing. One of two sizes of arrows may be

displayed depending on the vertical speed rate. The sensitivity of these arrows is set by an

authorized Garmin Aviation Service Center.

914.1.7 FAILURE ANNUNCIATION

If the unit detects an internal failure, the screen displays 'FAIL'. When 'FAIL' is annunciated no

transponder data is transmitted.

1 2 ... 189 190 191 192 193 194 195 196 197 198 199 ... 283 284

Sin comentarios

Side-Power SEP 100/185 T Manual de servicio Pagina 194