Side-Power SEP 100/185 T Manual de servicio descargar pdf (Pagina 280)

Section 924

KANNAD AF 406 ELT

924 - 4 Page Date: 29. September 2014

Pilot´s Operating Handbook

EXTRA 330LX

924.3 EMERGENCY PROCEDURES

• In case of a forced landing switch the remote switch in the rear instrument panel to the

"ON" position prior to touch down.

Although the ELT will be activated automatically after an aircraft accident or forced landing with high

G-force,

• switch additionally the remote switch in the rear panel to the "ON" position.

After sighting rescue aircraft:

• Switch the remote switch to the "ARM" position to prevent radio interference.

• Attempt contact with rescue aircraft with the radio transceiver set to a frequency of 121.5

MHz. If no contact is established, switch the remote switch to the "ON" position

immediately.

If the function of the remote switch is in doubt proceed as follows:

• Remove quick pins from the backrest adjustment and swivel the backrest forward to get

access to the ELT unit.

• Use the master switch at the ELT unit analogously.

FUNCTION CHECK OF THE ELT

• If the aircraft receiver is operable, check ELT function by listening on 121.5 MHz for ELT

transmission. Ensure that the ELT antenna is clear of any obstructions.

924.4 NORMAL PROCEDURES

It is recommended by the manufacturer to test the ELT to detect any possible failure.

An operational check must be performed regularly by a pilot or maintenance personnel from the

cockpit (Remote Control Panel). It is recommended to perform a self-test once a month but it

should not be done more than once a week.

Each self-test consumes energy from the battery. Should self-tests be carried out more often than

the maximum allowed, the battery life-time might be shorter than specified.

SELF-TEST PROCEDURE

• Check that the antenna is correctly connected

Do not perform self-test without antenna connected.

• Tune aircraft radio to 121.5 MHz and adjust volume to ensure you can hear it.

1 2 ... 275 276 277 278 279 280 281 282 283 284

Sin comentarios

Side-Power SEP 100/185 T Manual de servicio Pagina 280