Side-Power SEP 100/185 T Manual de servicio descargar pdf (Pagina 273)

Section 923

f.u.n.k.e TRT800H Transponder

Page Date: 12. March 2014 923 - 7

Pilot´s Operating Handbook

EXTRA 300LC

923.1.7 TRANSPONDER MODE SELECTION

Press MODE (repeatedly) to select from following Modes:

• STBY „Standby“

Transponder does not respond to any interrogation. Squitter and ADS-B output is not active.

• A C S „Mode A+C+S“

Standard condition; transponder responds to mode A, C and S interrogations.

• A – S „Mode A+S, no C“

Altitude is not transmitted (neither on C nor on S requests). All other Mode-S data as well as Mode-

A replies are transmitted.

If no 24-bit address (AA) was defined or entered as “000000“ the transponder operates as a Mode

A/C transponder, in that case the following Modes are possible apart from Standby:

• A C – „Mode A+C“

Transponder replies only on Mode A and Mode-C interrogations.

• A – – „Mode A“

Transponder replies only on Mode A interrogations.

N O T E

In STBY (Standby) mode, all transponder transmissions are disabled completely! There-

fore, the transponder is not visible in this mode to air traffic control or the anti-collision

systems onboard other aircraft.

Never use the STBY mode in flight unless you are requested to do so by air traffic control.

Always remember to put the transponder in active mode prior to take off!

923.1.8 SQUAWK-SETTING

The active Squawk is displayed in the upper line, while the standby Squawk is presented at the lower

line.

Setting the Standby Squawk:

• Press to set the cursor („^“), turn rotary knob to set numbers of the standby Squawk.

• Press to activate the Standby Squawk (this moves the current active Squawk into Standby)

1 2 ... 268 269 270 271 272 273 274 275 276 277 278 ... 283 284

Sin comentarios

Side-Power SEP 100/185 T Manual de servicio Pagina 273